14R2DC
14AG2-DC
1.5kV(at
?
2-2
A) in the case of the set. The set has been factory - Adjusted to the above-
m
A) for the set.
m
IMPORTANT SERVICE NOTES
never forget to check for such high voltage after the work.
*If there is a possibility that the high voltage fluctuates as a result of the repairing,
the high voltage completely.beam 0 beam 800 mentioned high voltage.excess X-ray radiation.lodged between the chassis and other metal parts in the receiver.cabinet backs, adjustment and compartment covers or shields, isolation resistor- ca- pacity networks, mechanical insulators etc.
Maintenance and repairing of this receiver should be done by quali- fied service personnel only.SERVICE OF HIGH VOLTAGE SYSTEM AND PIC- TURE TUBEWhen servicing the high voltage system, remove static charge from it by Connecting a 10K ohm Resistor in series with an insulated wire(such as a test probe) between picture tube dag and 2nd anode lead. (AC line cord should be disconnected from AC outlet.)1.Picture tube in this receiver employs integral implosion protection. 2.Replace with tube of the same type number for continued safety. 3.Do not lift picture tube by the neck. 4.Handle the picture tube only when wearing shatterproof goggles and after dischargingX-RAYThis receiver is designed so that any X-Ray radiation is kept to an absolute Minimum. Since certain malfunctions or servicing may produce potentially hazardous radiation with prolonged exposure at close range, the following precautions should be observed:1.When repairing the circuit, be sure not to increase the high voltage to more than 23.7kV(at2.To keep the set in a normal operation , be sure to make it function on 22.5kV3.Do not substitute a picture tube with unauthorized types and/or brands which may causeBEFORE RETURNING THE RECEIVERBefore returning the receiver to the user, perform the following safety Checks.1.Inspect all lead dress to make certain that leads are not pinched or that hardware is not2.Inspect all protective devices such as non-metallic control knobs, insulating fishpapers,
Height: 333.0mm Depth: 365.0mmHeight: 334.0mm Depth: 364.0mm
Weight(approx): 9.6 kg Weight(approx): 9.6 kg
C1(49.75MHz) thru C12(216.25 MHz) S1(105.25MHz) thru S36(423.25HMz)
C13(471.25MHz) thru C57(863.25MHz) S37(431.25MHz) thru S41(463.25MHz)
2-1
SPECIFICATIONS
Specifications are subject to change without prior notice.
Convergence.................................................................Self Convergence System Focus......................................................................Quadra-Potential ElectrostaticSweep Deflection......................................................................................Magnetic Intermediate Frequencies Picture IF Carrier..................................................................................38.9MHz Sound IF Carrier Frequency 6.5MHz..............................................................................................32.4MHz 6.0MHz..............................................................................................32.9MHz 5.5MHz..............................................................................................33.4MHz Colour Sub-Carrier Frequency............................................................34.47MHzPower Input......................................................100 ~ 240V AC 50/60 Hz, DC 12V Power Consumption 14R2DC/14AG2-DC....................................................................................62WAudio Power Output Rating 14R2DC/14AG2-DC.....................................................................5.0W(at Max.)Speaker Size 14R2DC/14AG2-DC...................................................5 x 9 cm Elliptic (2 pcs) Voice Coil Impedance 14R2DC/14AG2-DC..........................................................16 ohms at 400 HzAerial Input Impedance VHF/UHF..........................................................................75 ohms Unbalanced Receiving System....................................................CCIR SECAM/PAL B, G,D,K,ITuner Ranges VHF-Channels..........................................E2(48.25MHz) thru E12(224.25MHz) UHF-Channels......................................E21(471.25MHz) thru E69(855.25MHz)Dimensions 14AG2-DC................................................................................Width: 446.0mm 14R2DC....................................................................................Width: 446.0mmCabinet material....................................................................................All Plastics
2 |
ACEC
